Skip to main content
Fabric · Material guide

Cotton vs. Linen Fabric: Choose by Weave, Weight and Use

Cotton comes from seed fibers; linen comes from flax stems.

In this guide

    Cotton comes from seed fibers; linen comes from flax stems.

    Practical cotton and linen comparison
    Decision Cotton Linen
    Fiber origin Cotton seed fiber Flax bast fiber
    Fabric hand Ranges from crisp poplin to soft jersey Often crisp or textured; varies with finish
    Stretch Depends on knit/weave and added elastane Depends on knit/weave and added elastane
    Care and shrinkage Read the specific fabric label and test Read the specific fabric label and test
    Useful samples to compare Quilting cotton, lawn, denim, jersey Shirting, dress linen, canvas-weight linen

    What the fiber name establishes

    Cotton textile fibers develop as hairs on the cotton seed; linen is made from flax bast fibers from the plant stem. Those origin facts do not specify a cloth’s weave, thickness, opacity or drape. A cotton/linen blend is a separate fabric with its own percentages and finish. For a summer shirt, compare cloths intended for shirts at similar weights before deciding; comparing heavy cotton denim with light linen shirting mostly compares construction and weight.

    Hypothetical cloth sample changes from 10 inches before care to 9.7 inches after care, giving 3 percent dimensional shrinkage.
    Hypothetical arithmetic only. A 3% change is not a typical rate assigned to cotton or linen; measure both axes using the care intended for the finished article.

    Choose a fabric, not just a fiber

    A lightweight cotton voile and heavy cotton canvas behave very differently. Likewise, an open linen gauze and a dense linen suiting will not share the same opacity, seam strength or drape. Fold, hang and scrunch samples to compare the behavior required by your pattern. The table describes choices to inspect rather than a ranked laboratory test.

    A useful sample test

    • Hold the sample up to light and over a contrasting layer to check opacity.
    • Hang it in a fold to judge the amount of body or drape.
    • Sew two layers with a needle and thread appropriate to the actual fabric; inspect skipped stitches and puckering.
    • Mark a measured sample, launder as allowed by the label, dry and remeasure both directions. Do not assume a fixed 3–5% or 5–10% shrinkage from the fiber name.

    Match construction to the project

    For accurate patchwork, stable fabric of compatible weight is easier to plan than mixing very different constructions. For a loose summer garment, choose the drape and opacity the pattern calls for. For close-fitting activewear, measure stretch and recovery; neither cotton nor linen content alone establishes that the fabric is suitable.

    Care before cutting

    Follow the seller’s care instructions. If the finished item will be washable, a sample wash can reveal shrinkage, color release and finish changes before the main cut. Use a press setting suitable for the complete fabric or blend. Exact wet-strength percentages and guaranteed cooling or lifespan claims are not needed to make this selection.

    See grainline and bias and needle selection for related checks.

    Choose between two particular cloths

    For a sharp-collared shirt, favor the sample that presses and holds the intended collar while remaining comfortable; either fiber could meet that need. For a fluid skirt, compare hanging folds and opacity in the intended layers. If both meet the pattern, choose between texture, acceptable wrinkling, permitted care and total project cost. In the hypothetical 10-to-9.7-inch measurement above, shrinkage is 3%; measure both axes of each candidate rather than assigning this rate to either fiber. Save the sample and preparation notes so a later purchase can be compared fairly.

    Keep your project moving

    Measure before the first cut.

    Estimate yardage from your required dimensions, fabric width and chosen shrinkage allowance.

    Explore the planning tool

    Sources & editorial notes