Skip to main content
Fabric · Free planning tool

Fabric Yardage & Cut Calculator

Estimate yardage and meterage from cut piece dimensions, quantities, bolt width, and pre-wash shrinkage allowance.

Start with the example, then enter your measurements. Results update as you type.

Your measurements

Unit System

Width of rectangular cut piece including seam allowances; maximum 59″ on the widest supported bolt.

Length of rectangular cut piece along grainline.

Total identical pieces to cut.

Nominal fabric bolt width.

Use a measured test wash where possible. Assumes the same shrinkage in width and length; fiber name alone does not determine the percentage.

View result ↓
Total Fabric Needed
Calculating...

Your project details

Cutting Grid Layout:—
Shrinkage Length Added:—
Usable Bolt Cross-Width:—
What this means

Awaiting valid inputs...

⚡ Calculated in your browser · Instant local output
Keep your calculation.

Download a worksheet with your inputs, result and method.

On this page
The method

How the calculation works

Usable Width = (Bolt_Width - 1.0″) × (1 - Shrink% / 100) ; Pieces/Row = floor( Usable Width / Piece_Width ) ; Rows Needed = ceil( Quantity / Pieces/Row ) ; Cut Length = Rows Needed × Piece_Length ; Total Yards = ceil( ((Cut Length / (1 - Shrink% / 100)) / 36) × 8 ) / 8

Calculates pieces fitted across usable bolt width (nominal minus 1.0″ selvage allowance), reduces usable width for assumed shrinkage, calculates rows needed along length and divides the required finished length by the retained-length fraction, and converts to commercial 1/8-yard increments.

Usable Width
Nominal width minus 1 inch for selvages, then reduced by the selected shrinkage fraction
Pieces/Row
Number of cuts fitted side-by-side across the bolt
Rows Needed
Number of cross-cuts along the bolt length
Shrink%
Pre-treatment wash shrinkage reserve
Commercial Yardage
Length rounded up to nearest 1/8 yard (0.125 yd)

Rounding: Total fabric yardage rounds upward to the nearest 1/8 yard (0.125 yd). The corresponding meter purchase estimate rounds upward to 0.01 m, never below the rounded yard quantity.

Follow the numbers

Worked example

Example: Two 18″ × 18″ pillow panels on a 44″ bolt with 5% shrinkage: Usable width = (44 - 1) × 0.95 = 40.85 inches; floor(40.85 / 18) = 2 pieces/row. Rows needed = ceil(2 / 2) = 1 row. Raw cut length = 1 × 18″ = 18″. With 5% shrinkage reserve: 18″ / 0.95 = 18.947″. Exact yards = 18.947 / 36 = 0.5263 yd → commercial rounding to nearest 1/8 yard = 5/8 yard (0.625 yds / 0.58 m to purchase).

Before you cut or cast on

Things to know

Assumes single-directional cutting with grainline parallel to selvage. Does not include fussy pattern matching or plaids.

These are planning estimates under the stated model. Check your measurements and pattern, and test a sample before committing materials.